-
Solutions
- Amusement
- Automated Material Handling
- 汽车解决方案
- IIoT Solutions
-
PROFINET® Device to Modbus® Serial Gateway with four serial ports
PLX31-PND-MBS4
The PROFINET device to Modbus Serial gateway offers bi-directional data transfers between a PROFINET Controller and Modbus serial (RTU and ASCII) devices. Each Modbus serial port can be configured as either a Modbus master or slave. The PROFINET interface operates as a PROFINET device (slave).
The PLX31-PND-MBS4 gateway is a stand-alone DIN-rail mounted unit that provides Ethernet connectivity for network communications, remote configuration, and diagnostics. The onboard SD Card slot (SD card optional) is used for storing configuration files that can be used for recovery, transferring the configuration to another gateway, or general configuration backup.
图像
Click on image(s) to enlarge
特性 优势
- PROFINET v2 certification with PROFINET class A compliance
- Field-proven with thousands of Modbus serial devices, and multiple PROFINET controllers from multiple vendors
- Remotely view and diagnose Modbus and PROFINET networks
- Remote configuration via the free, intuitive, ProSoft Configuration Builder (PCB) software
- Each Modbus serial port supports master or slave mode
- Secure module configuration via module switch (v1.04 and greater)
- Up to 10,000 16-bit registers can be used to exchange large amounts of data.
规格
PROFINET Specifications
Specification
Description
Driver Type
Class A Device
PROFINET I/O Data
1440 bytes IN, 1440 bytes OUT
Exchange Types
Cyclic Real-time (RT) and Acyclic Data
Modbus Serial Specifications
Command List
Up to 100 commands per master port, each fully configurable for Function Code, slave address, register to/from addressing and word/bit count.
Supported Modbus Function Codes
1: Read Coil Status
2: Read Input Status
3: Read Holding Registers
4: Read Input Registers
5: Force (Write) Single Coil
6: Preset (Write) Single Holding Register
15: Force (Write) Multiple Coils
16: Preset (Write) Multiple Holding Registers
22: Mask Write Holding Register (slave only)
23: Read/Write Holding Registers (slave only)
Software configurable communication
parameters
Baud rate: 110 baud to 115.2 kbps
Parity: None, Even, Odd
Data Size: 7 or 8 bits
Stop bits: 1 or 2RTS on/off delay: 0 to 65535 milliseconds
Modbus Modes: RTU with CRC-16 or ASCII with LRC error checking
Floating Point Data supported, support for Enron and Daniel
Polling of Command List
Configurable polling of command list, including continuous and on change of data
Status Data
Error codes available on an individual command basis. In addition, a slave status list is maintained per serial port
Node Address
1 to 247 (software selectable)
RS Interface
RS232, RS422, and RS485
硬件
Hardware Specifications
Specification
Description
Power Supply
24 VDC nominal
10 to 36 VDC allowed
Positive, Negative, GND TerminalsCurrent Load
24 VDC nominal @ 300 mA
10 to 36 VDC @ 610 mA maximum
Operating Temperature
-25°C to 70°C (-13°F to 158°F )
Storage Temperature
-40°C to 80°C (-40°F to 176°F )
Relative Humidity
5% to 95% RH with no condensation
Shock
IEC 60068-2-27; 15G @ 11ms, 3-Axis (Operational)
IEC 60068-2-27; 30G @ 18ms, 3-Axis (Non-Operational)
Vibration
IEC 60068-2-6; 5G @ 10 to 150 Hz
Dimensions
5.38 x 1.99 x 4.38 in, 13.67 x 5.05 x 11.13 cm (H x W x D)
LED Indicators
For configuration and protocol status errors
Ethernet Port
*10/100Mbit RJ45 Connector Electrical Isolation 1500 Vrms at 50 to 60 Hz for 60 seconds, applied as specified in section 5.3.2 of IEC 60950: 1991
*Ethernet Broadcast Storm Resiliency - less than or equal to 5000 [ARP] frames-per-second and less than or equal to 5 minutes durationNumber of Serial Ports
4
Shipped With Each Unit
2.5 mm screwdriver, J180 Power Connector, DB9 to Screw Terminal Adapter
证书
ATEX Letter of Conformity 107.32 kB 最后修改 2022.05.12 CB Safety 348.30 kB 最后修改 2022.10.20 Korean KC Registration 974.32 kB 最后修改 2020.07.07 PROFINET Certificate 251.41 kB 最后修改 2025.03.10 Declaration of Conformity (RoHS/CE) 114.24 kB 最后修改 2022.06.01 Country Approval - Eurasian Customs Union Conformity (EAC) (Wired) 1.92 MB 最后修改 2020.07.10 UL Certificate of Compliance 233.35 kB 最后修改 2022.11.16