EtherNet/IP™ to DH+ Gateway
What do you need help with?
Why are my PLX gateway modbus serial commands not executing despite being enabled?
are not intending to use this feature, but the Command Control Reg value is set to anything but -1, change the value to -1 to disable this feature, and download the updated configuration. Without the CCR to override
Read moreMy RX light is on solid, what might that indicate?
of positive to positive). Try swapping the wiring to pins 1 and 8 on our port. The port is in RS232 mode- This suggests that a constant electrical signal is hitting our receive pin which should never occur
Read moreConfiguration Storage on the PLX31 & PLX32 Gateways
and removed while the gateway is still powered on. To copy a configuration from a SD Card to the internal non-volatile storage: 1) Insert SD Card 2) Upload from device to PC. This will copy the config
Read moreSD Card Support on the PLX31 & PLX32 Series Gateways
, but the following is a general guideline on what type of SD card and partition formats are supported by the PLX gateways: 1)All SD cards formatted with FAT/FAT16 of any size should be supported. 2)SD/SDHC cards
Read moreHow to compile a C++ project using the sample LDM makefile
Although the samples included with the LDM modules are written in C, it is also possible to compile the C++ code as a C++ project. 1) Rename your source code extensions from .cpp to .c (case
Read more