- Solutions
- 产品
- 服务与支持
-
新闻与活动
- ProSoft Insights (Blog)
- Podcast
- 成功案例
-
新 Featured ProductsKnowledge Base
Universal QuickServer Gateway
Categories
What do you need help with?
What is the default addressing schema for the EtherNet IP DCSNet(2) Slave interface?
When using the DCSNet(2) firmware in a slave configuration the addresses use the following layout:Drop 0 = N100:0 - N100:63Drop 1 = N101:0 - N101:63Drop 2 = N102:0 - N102:63etc....The first 32
Read moreWhen operating as a DCSNet(2) slave can the AN-X-AMX gateway be configured to emulate more than 1 drop area?
When operating as a DCSNet(2) slave can the AN-X-AMX gateway be configured to emulate more than 1 drop area?
Read moreWhat do the jumpers do on the PLX3x gateways?
. To place the gateway into Mode 2 follow these steps: 1) Power down the gateway 2) Place the jumper in mode 2 (horizontally on the middle pins) 3) Power up the gateway At this point the gateway will use
Read moreWhy am I getting: Download was successful but Module failed to reboot in 60 seconds
. If we don't have a backplane connection, this will result in the "download was sucessful but module failed to reboot" error. Common causes include: 1) Your Compact Logix is not in run mode. 2) Your
Read moreDoes the AN-X(2)-AB-DHRIO gateway running the RIO HMI firmware support multiple block transfers to the same Rack, Group, and Slot?
4)Rack,0o02,1,4 ; define rack at octal 02, start quarter 1, and quarter 4; Allows multiple BTRs and BTWs to occur to the same Rack, Group, and Slot.BtByLenbtW,0o02,0,0,7, 0,64, ; define btw, rack 02
Read more