Universal QuickServer Gateway
What do you need help with?
SD Card Support on the PLX31 & PLX32 Series Gateways
formatted with FAT32 should be supported. We have tested SDHC cards up to 4GB in size. 3)exFAT and NTFS are not supported. 4)Any other partition formats are more than likely not supported.
Read moreWhat are common things that prevent reliable DH+ communications on the AN-X(2)-AB-DHRIO gateway running the DH+ Bridge FW?
(for 230k4 use 82 ohm resistors) 2) Ensure that at least 10' or 3 meters of cable is used between gateway and any surrounding nodes 3) Ensure that the outer braided shield has been grounded in one place
Read moreWhy am I getting: Download was successful but Module failed to reboot in 60 seconds
Prosoft card's Add-On Instruction is either not installed, or the rung it is on is not being completed, scheduled, or jumped to. 3) You have not yet installed the right end cap. 4) There are more then 3
Read moreDoes the AN-X(2)-AB-DHRIO gateway running the RIO HMI firmware support multiple block transfers to the same Rack, Group, and Slot?
4)Rack,0o02,1,4 ; define rack at octal 02, start quarter 1, and quarter 4; Allows multiple BTRs and BTWs to occur to the same Rack, Group, and Slot.BtByLenbtW,0o02,0,0,7, 0,64, ; define btw, rack 02
Read moreWhat driver should be used in RSLinx Classic to browse or get data from PLC5 or SLC controllers on a DH+ network?
The best driver to use in RSLinx Classic is the Ethernet Devices driver. Specify the IP Address of the AN-X(2)-AB-DHRIO gateway in the driver configuration. The gateway emulates a 4 slot
Read more