Universal QuickServer Gateway
What do you need help with?
Can the Johnson Control's N2 protocol be used with the RadioLinx FHS Serial radio?
isn't transmitted until the entire message comes into the radio. 256 bytes at 9600 baud takes 267ms one way. So this won't work. Use transparent mode without the gap timer. Each repeat adds 12.5ms
Read moreI have a ProSoft Modbus Master solution and would like to know, is the Slave Status List the best place to monitor for communications health of the network?
, it is usually a good idea to include a 5-15 second proving timer in the alarm logic to prevent 'nuisance' alarms.
Read moreDo ProSoft AFC Flow Computer solutions support "ASME MFc-6M", "API-11" and/or "API-12" calculation standards for measuring lubricating oils?
are configured parameters, one of which can be adjusted for flow rate effects using a linearization curve of up to 5 data points -- same as for gases using AGA 7; these are covered by MPMS Ch 12. The CTPL
Read moreHow do I transfer data from a PLC5 Processor and the MVI71-ADM module using Block Transfers?
The transfer of data between the PLC5 processor and the MVI71-ADM can be made in two ways: using block transfers or using the side connector. In this application note we will discuss the way to do ... How do I transfer data from a PLC5 Processor and the MVI71-ADM module using Block Transfers?
Read moreHow do I enter special ASCII characters in an ST File? ie: & $
To enter a special ASCII character in an st file use a " " and then the hex code for the character. For example: to enter "c:" one would enter "c:5c" in the string file.
Read more