What do you need help with?
I have a xxxx-xxx-DFCM4 with Pass-Through enabled. The Pass-Through (Debug/CFG) port and the Port 0 DFCM port shows no activity. What am I doing wrong?
When using a ProLinx gateway that supports DF1 pass-through, you willneed to enable at least one command on DFCM port 0. If no commands are really needed, than the poll rate on a single command can ... DF1, Pass-Through, passthrough, passthru
Read moreCan I use 2 AN-X-MOD gateways running as scanners in a redundant application?
The AN-X-Mod gateway can be used in a redundant scanner application with the following considerations: 1) They cannot operate on completely separate S908 networks. They need to share the same
Read moreWhat is the difference between your MVI56E-MCM and MVI56E-MCMR modules?
The MVI56E-MCM and MVI56E-MCMR modules share nearly the same Modbus functionality, but the MVI56E-MCMR module pages user data in a block of 40 words at a time as opposed to 200 words for the MCM
Read moreWhat is the purpose of the deadband parameter in the DNP module?
# is the offset from the start of the analog # input database. # # point# class deadband start 6 1 50 7 1 10 8 2 100 end The AI Deadband being set to a value of 1000
Read moreHow do I setup my 3170-PDP in Step 7 software?
Make sure to drop the "3170-PDP 1.2 status" information into the first slot, then each of your I/O modules after that. Any unused slots must have a "flex I/O empty slot" defined in the configuration
Read more